EZO-PMP™ Advanced Kit


You may also like…


Add & Save

4+ units


10+ units


25+ units


The EZO™ Advanced pump kit comes with everything found in our original EZO pump kit and more!

Having the pump already mounted into an enclosure saves a lot of time.
The power connector and data cable with breakout board make integration onto your device FAST!

*This device comes defaulted to I2C mode*
*You can switch it back to UART mode if desired*

SizeMetric: L = 145mm x W = 90.5mm x H = 80mm
Inch: L = 5.7″ x W = 3.5″ x H = 3.1″
Enclosure protectionIP-64
Enclosure materialBody: Polycarbonate plastic
Screws: Stainless steel
Pump:*This pump is set to I2C mode by defualt*
*It can be change to UART mode.*
*See data sheet for instructions*
Flow rate0.5ml to 105ml/mins
Accuracy+/- 1%
Modes of operationContinuous dispensing
Volume dispensing
Dose over time mode
Constant flow rate
Dispense at startup
Connector5 lead data cable
CalibrationSingle point
Supplied tubing15.24 cm
Tubing sizeAny 5mm O.D. tubing
Data protocolUART & I2C
Default I2C address103 (0x67)
Operating voltage3.3V – 5V (logic)
12V – 24V (motor)
Pump head2 meters
Data formatASCII
Food safeYes

You may also like…

Scroll to Top

To track your order please enter your Order ID in the box below and press the "Track" button. This was given to you on your receipt and in the confirmation email you should have received.