1/4" Pre-Filter
#Com-202F
You may also like…
Add & Save
|
4+ units |
$23.75 |
|
10+ units |
$23.10 |
|
25+ units |
$22.50 |
This pre-filter is intended to be used alongside the Atlas Scientific 1/4” flow meter.
If water with particulate matter will be passing through the flow meter, a pre-filter of at least 80 microns must be used. The blades of the paddle wheel can become jammed by debris if you are not using a pre-filter. Jammed paddle wheel blades will not damage the flow meter; however, it will not be possible to get accurate flow readings until the blockage has been removed.
• 80 Mesh stainless steel pre-filter (178 microns)
• 1/4” Male NPT Input/Output
• Max pressure of 861 kPa (120 PSI)
• Max temp 100°C (212°F)
This pre-filter is intended to be used alongside the Atlas Scientific 1/4” flow meter.
If water with particulate matter will be passing through the flow meter, a pre-filter of at least 80 microns must be used. The blades of the paddle wheel can become jammed by debris if you are not using a pre-filter. Jammed paddle wheel blades will not damage the flow meter; however, it will not be possible to get accurate flow readings until the blockage has been removed.
• 80 Mesh stainless steel pre-filter (178 microns)
• 1/4” Male NPT Input/Output
• Max pressure of 861 kPa (120 PSI)
• Max temp 100°C (212°F)
