EZO-PMP™ Basic Kit
#KIT-PMP
You may also like…
-
-
-
-
New!
Add & Save
|
4+ units |
$109.99 |
|
10+ units |
$106.99 |
|
25+ units |
$103.99 |
Arduino Uno Sample Code- Arduino Mega / Giga Sample Code
- Arduino I2C Sample Code
Raspberry Pi Sample Code (I2C)
The EZO-PMP™ Kit comes with:
Peristaltic pump with controller, 2 x 30.48 cm long pump tubes, 2 inline tubing connectors, 12 volt power supply, power supply connector, data cable with 5 pin male header, and a 10ml graduated cylinder (for calibration).
The replacement cassettes can be autoclave sterilized.
Flow rate 0.5ml to 105ml/mins Accuracy +/- 1% Viscosity 0.1 – 2,000 cP Modes of operation Continuous dispensing Volume dispensing Dose over time mode Constant flow rate Dispense at startup Connector 5 lead data cable Calibration Single point Supplied tubing 2 x 30.48 cm Tubing size Any 5mm O.D. tubing Data protocol UART & I2C Default I2C address 103 (0x67) Operating voltage 3.3V – 5V (logic) 12V – 24V (motor) Pump head 8.1 meters (26.5’) Data format
ASCII Food safe Yes
You may also like…
-
-
-
-
New!
