Subtotal: $69.98
SGL-PMP-BX™
#SGL-PMP-BX
You may also like…
Add & Save
4+ units |
$114.00 |
10+ units |
$111.00 |
25+ units |
$108.00 |
Arduino Uno Sample Code
Arduino Mega Sample Code
Arduino I2C Sample Code
Raspberry Pi Sample Code (I2C)
The SGL-PMP-BX™ comes with everything found in our original EZO pump kit and more!
Having the pump already mounted into an enclosure saves a lot of time.
The power connector and data cable with breakout board make integration onto your device FAST!
*This device comes defaulted to I2C mode*
*You can switch it back to UART mode if desired*
Enclosure: Size Metric: L = 145mm x W = 90.5mm x H = 80mm Inch: L = 5.7″ x W = 3.5″ x H = 3.1″ Enclosure protection IP-64 Enclosure material Body: Polycarbonate plastic Screws: Stainless steel Pump: *This pump is set to I2C mode by defualt* *It can be change to UART mode.* *See data sheet for instructions* Flow rate
0.5ml to 105ml/mins
Accuracy +/- 1%
Modes of operation
Continuous dispensing
Volume dispensing
Dose over time mode
Constant flow rate
Dispense at startup
Connector
5 lead data cable
Calibration Single point
Supplied tubing
15.24 cm
Tubing size
Any 5mm O.D. tubing
Data protocol
UART & I2C
Default I2C address
103 (0x67)
Operating voltage
3.3V – 5V (logic)
12V – 24V (motor)
Pump head
8.1 meters (26.5’)
Data format
ASCII
Food safe Yes
Arduino Uno Sample Code
Arduino Mega Sample Code
Arduino I2C Sample Code
Raspberry Pi Sample Code (I2C)
The SGL-PMP-BX™ comes with everything found in our original EZO pump kit and more!
Having the pump already mounted into an enclosure saves a lot of time.
The power connector and data cable with breakout board make integration onto your device FAST!
*This device comes defaulted to I2C mode*
*You can switch it back to UART mode if desired*
Enclosure: Size Metric: L = 145mm x W = 90.5mm x H = 80mm Inch: L = 5.7″ x W = 3.5″ x H = 3.1″ Enclosure protection IP-64 Enclosure material Body: Polycarbonate plastic Screws: Stainless steel Pump: *This pump is set to I2C mode by defualt* *It can be change to UART mode.* *See data sheet for instructions* Flow rate
0.5ml to 105ml/mins
Accuracy +/- 1%
Modes of operation
Continuous dispensing
Volume dispensing
Dose over time mode
Constant flow rate
Dispense at startup
Connector
5 lead data cable
Calibration Single point
Supplied tubing
15.24 cm
Tubing size
Any 5mm O.D. tubing
Data protocol
UART & I2C
Default I2C address
103 (0x67)
Operating voltage
3.3V – 5V (logic)
12V – 24V (motor)
Pump head
8.1 meters (26.5’)
Data format
ASCII
Food safe Yes