Surveyor™ Analog Isolator

#SRV-ISO

You may also like…

$27.99 USD

Add & Save

4+ units

$26.99

10+ units

$25.99

25+ units

$24.99

(Previously known as the Gravity Analog Isolator)

The Surveyor™ Analog Isolator is designed to work exclusively with our Surveyor line of low-cost embedded meters. These isolators remove all electrical interference coming from other probes or pumps in the same water you are testing.  It converts the analog output from a Surveyor pH, Surveyor ORP, or Surveyor D.O. meter to both, a PWM and a voltage signal.

The PWM signal can then be easily converted back to a noise-free reading. Because this isolator uses PWM, it can be connected to a micro-controller that does not have an ADC.

The voltage signal converts the sensor value into 0 – 3 Volts, good for a micro-controller that does have an ADC

*A Raspberry Pi cannot accurately read PWM or analog voltage without a 3rd party hat.

Data output10.6 KHz PWM
0-3 Volts
Voltage input3.0V − 5.0V
ConnectorHeader pins
Current consumption5V – 23 mA
3.3V – 15.7 mA
Carrier Board dimensions42mm x 32mm (2.2″ x 1.2″)
Weight13 grams
The Surveyor™ Analog Isolator comes with
(4) standoffs and screws

You may also like…

Scroll to Top

To track your order please enter your Order ID in the box below and press the "Track" button. This was given to you on your receipt and in the confirmation email you should have received.